Model Ship Builder :: Forums :: Build Logs :: POB Build Logs |
|
<< Previous thread | Next thread >> |
Gulnara (Krick) 1:50 |
Go to page 1 2 3 ... 14 15 16 | |
Moderators: Winston, aew
|
Author | Post | ||
Gene Bodnar |
| ||
![]() ![]() Registered Member #126 Joined: Tue Jul 21 2009, 11:20amPosts: 1778 | Arthur, Great-looking ship. You've accomplished a piece of very fine workmanship, especially your rigging. Gene | ||
Back to top | | ||
Winston |
| ||
winston![]() ![]() ![]() Registered Member #1 Joined: Sat Jun 13 2009, 02:08pmPosts: 2556 | Very nice Arthur. | ||
Back to top | | ||
Peter Foele |
| ||
![]() Registered Member #4491 Joined: Mon Sep 22 2014, 01:09pmPosts: 142 | very nice indeed. your builds are an inspiration | ||
Back to top | | ||
aew |
| ||
Arthur![]() ![]() ![]() Registered Member #1929 Joined: Wed Nov 30 2011, 03:05pmPosts: 3019 | This nearly got forgotten in the original logs and I almost managed to forget it again!
23rd October 2011
An addendum to the build log.
I’ve just realised that there was an outstanding job still to complete. At the time I built the two ship’s boats, I put off making the oars for them, and somewhere along the way, the job got forgotten. I was going to make the shafts out of round stock, but I couldn’t find anything suitable. In addition, if I had found something, I would have had to then add something to fit the thole pins. I eventually settled on square section timber, suitably carved and sanded. Here’s the kit of parts with the ends of the shafts slotted to take the blades:
PICT_G_5001
The two square sections locate the oars very nicely. Only another 16 left to carve! And, some time later:
PICT_G_5002
After a bit of fiddling with a couple of pairs of tweezers, here they are lashed in place:
PICT_G_5003
| ||
Back to top | | ||
Mike 41 |
| ||
![]() ![]() Registered Member #702 Joined: Fri Feb 05 2010, 10:37pmPosts: 1249 | Nice work Arthur. | ||
Back to top | | ||
Bill Edgin |
| ||
![]() ![]() Registered Member #4362 Joined: Wed Jan 22 2014, 02:37amPosts: 373 | It is nice work. Well done. | ||
Back to top | | ||
aew |
| ||
Arthur![]() ![]() ![]() Registered Member #1929 Joined: Wed Nov 30 2011, 03:05pmPosts: 3019 | Thanks gents. | ||
Back to top | | ||
Go to page 1 2 3 ... 14 15 16 | |