Model Ship Builder :: Forums :: Build Logs :: POB Build Logs |
|
<< Previous thread | Next thread >> |
Dumas PT Boat (PT105) 1:30 scale by MOG |
Go to page 1 2 3 ... 16 17 18 | |
Moderators: Winston, aew
|
Author | Post | ||
Mog |
| ||
![]() Registered Member #1563 Joined: Fri Apr 08 2011, 08:15pmPosts: 146 | Torpedo tubes complete , test fit went ok , now they go back in drydock until there needed ![]() ![]() ![]() | ||
Back to top | | ||
Mog |
| ||
![]() Registered Member #1563 Joined: Fri Apr 08 2011, 08:15pmPosts: 146 | Fabricated the throttle control bars, the mufflers are molded from resin. I think its time to paint the hull and deck next. ![]() | ||
Back to top | | ||
Mog |
| ||
![]() Registered Member #1563 Joined: Fri Apr 08 2011, 08:15pmPosts: 146 | Canvas spray shield attached to the aft gun tub. Tub not attached yet so it’s placed at an angle for photo purpose The “Canvas” process --Took a piece of old cotton tee shirt, stretched it out very tight tacked it down, several coats of spray primer was applied to both sides, followed by several coats of tan/ OD green regular can spray paint The drying, spraying process made the cotton stiff. Glued a plastic rod to the top to hold its shape, then made holes 5 mm apart in the top, sewed to the rail with rigging line treated with wax and white glue solution. Ship rigging experience came in handy here. Added the hull drain & bilge ports ready for clean-up & weathering ![]() ![]() ![]() | ||
Back to top | | ||
bensid54 |
| ||
![]() ![]() Registered Member #2957 Joined: Wed Jun 13 2012, 05:43amPosts: 1010 | I like it!!! | ||
Back to top | | ||
Go to page 1 2 3 ... 16 17 18 | |
Powered by e107 Forum System